LED AND LCD DISPLAY

-

 

Differences Between LCD and LED




Differences between LCD and LED are important to understand as they are both very co-related and it is possible to get confused between one and the other. LCD is the abbreviation for liquid crystal display while LED is the abbreviation for light-emitting diodes. They differ from one another in the fact that LCDs usually use fluorescent lights while lights use light-emitting diodes.

The structure of both LCD and LED is quite the same as the technology behind these screens is the same. The differing television types have two different layers of polarized glass and through this glass, the liquid crystals get blocked as well as pass the light. Thus, this is one of the key differences and similarities between LCD and LED.



LCD Vs LED

The table given below lists the differences between LCD and LED. In short, knowing about LCD Vs LED will help to a greater extent.

Difference between LCD and LED
LCDLED
LCD stands for liquid crystal display.LED stands for light-emitting diodes.
All LCDs are not a subset of LED TV.All LEDs are a subset of LCD TV.
LCDs primarily use fluorescent lights.LEDs use light-emitting diodes.
Fluorescent lights used are usually placed behind the screen.Light-emitting diodes are usually placed behind the screen or around the edges.
LCDs are usually thicker and lack energy efficiency compared to LEDs.LEDs are much thinner and are much more energy-efficient.

 


Comments

Post a Comment

Popular posts from this blog

Alternating Current

-
Image
  What Is Alternating Current? An  alternating current  can be defined as a current that changes its magnitude and polarity at regular intervals of time. It can also be defined as an electrical current that repeatedly changes or reverses its direction opposite to that of Direct Current or DC, which always flows in a single direction as shown below From the graph, we can see that the charged particles in AC tend to start moving from zero. It increases to a maximum and then decreases back to zero completing one positive cycle. The particles then reverse their direction and reach the maximum in the opposite direction after which AC again returns to the original value completing a negative cycle. The same cycle is repeated again and again. Alternating currents are also accompanied usually by alternating voltages. Besides, alternating current is also easily transformed from a higher voltage level to a lower voltage level.
Read more

SOLAR TRANSFORMERS

-
Image
  The transformers required for wind power and solar DPV require special design features to meet the challenging operating conditions. The industry today has developed different types of transformers for the application. The last few decades have seen very rapid development of renewable energy, especially, distributed photovoltaic (DPV) and wind power. It is estimated that at least 40 per cent of electricity generation by year 2040 would be from renewable energy sources and this would give appreciable reduction of the present level of carbon dioxide emissions of about 10 billion tons per year. The transformer industry is rising to this challenge and has developed special transformers for the DPV generation and wind generation. Transformers are critical components in solar energy production and distribution. Historically, transformers have ‘stepped-up’ or ‘stepped-down’ energy from non-renewable sources. There are different types of solar transformers including distribution, station, su
Read more