Interfacing Techniques in 8051

-

 Interfacing is one of the important concepts in microcontroller 8051 because the microcontroller is a CPU that can perform some operation on a data and gives the output. However to perform the operation we need an input device to enter the data and in turn output device displays the results of the operation. Here we are using keyboard and LCD display as input and output devices along with the microcontroller.

Interfacing is the process of connecting devices together so that they can exchange the information and that proves to be easier to write the programs. There are different type of input and output devices as for our requirement such as LEDs, LCDs, 7segment, keypad, motors and other devices.

Here is given some important modules interfaced with microcontroller 8051.

1. LED Interfacing to Microcontroller:

Description:


LEDs are most commonly used in many applications for indicating the output. They find huge range of applications as indicators during test to check the validity of results at different stages. They are very cheap and easily available in a variety of shape, color and size.


Light Emitting Diode



Light Emitting Diode

The principle of operation of LEDs is very easy. A simple LEDs also servers as a basic display devices, it On and OFF state express meaning full information about a device. The common available LEDs have a 1.7v voltage drop that means when we apply above 1.7V, the diode conducts. The diode needs 10mA current to glow with full intensity. 

Comments

Post a Comment

Popular posts from this blog

Alternating Current

-
Image
  What Is Alternating Current? An  alternating current  can be defined as a current that changes its magnitude and polarity at regular intervals of time. It can also be defined as an electrical current that repeatedly changes or reverses its direction opposite to that of Direct Current or DC, which always flows in a single direction as shown below From the graph, we can see that the charged particles in AC tend to start moving from zero. It increases to a maximum and then decreases back to zero completing one positive cycle. The particles then reverse their direction and reach the maximum in the opposite direction after which AC again returns to the original value completing a negative cycle. The same cycle is repeated again and again. Alternating currents are also accompanied usually by alternating voltages. Besides, alternating current is also easily transformed from a higher voltage level to a lower voltage level.
Read more

SOLAR TRANSFORMERS

-
Image
  The transformers required for wind power and solar DPV require special design features to meet the challenging operating conditions. The industry today has developed different types of transformers for the application. The last few decades have seen very rapid development of renewable energy, especially, distributed photovoltaic (DPV) and wind power. It is estimated that at least 40 per cent of electricity generation by year 2040 would be from renewable energy sources and this would give appreciable reduction of the present level of carbon dioxide emissions of about 10 billion tons per year. The transformer industry is rising to this challenge and has developed special transformers for the DPV generation and wind generation. Transformers are critical components in solar energy production and distribution. Historically, transformers have ‘stepped-up’ or ‘stepped-down’ energy from non-renewable sources. There are different types of solar transformers including distribution, station, su
Read more

Difference Between AC And DC Motor

-
  Difference Between AC And DC Motor The difference between AC and DC Motor are discussed below: AC Motor vs DC Motor AC Motor DC Motor AC motor runs on alternating current. DC motors operate on direct current. There is no need for conversion of current in AC motors. Like AC. There is no need for conversion of current in AC motors. Like AC. AC motors are used where power performance is demanded for extended periods of time. DC motors are used where the speed of the motor needs to be controlled externally. AC motors can be single-phase or three-phase. All DC motors are single phase. In an AC motor the armature does not rotate while the magnetic field keeps rotating continuously. In a DC motor, the armature rotates while the magnetic field rotates. Repairing AC motors is not expensive. DC motors are very expensive to repair. Brushes are not used in AC motor. Brushes are used in DC motor. AC motors have a very long life span DC motors do not have a very long life span. The speed of AC mot
Read more