Resistors in Series and Parallel Combinations

-

 Resistors in Series and Parallel Combinations

A resistor is a passive two-terminal electrical component that implements electrical resistance as a circuit element. Resistors reduce the current flow and lower voltage levels within circuits. Most circuits often have more than one resistor to limit the flow of charges in a circuit. The two simplest combinations of resistors are – series and parallel. In this article, we will be discussing resistors in series and parallel combinations.

Circuit Components

Basic Electrical Circuit

A circuit is composed of conductors (wire), power source, load, resistor, and switch. A circuit starts and ends at the same point. Usually, copper wire without insulation is used as a conductor. A switch is used to make or break a circuit. Resistors control the flow of the electric current in a circuit. A resistor is a passive element which means that it only consumes power but does not generate power. A load in a circuit consumes electrical energy and converts it into other forms of energy like light, heat, etc. A load can be a light bulb, fan, etc. Now let us know about resistors in series and parallel combinations.

Comments

Post a Comment

Popular posts from this blog

Alternating Current

-
Image
  What Is Alternating Current? An  alternating current  can be defined as a current that changes its magnitude and polarity at regular intervals of time. It can also be defined as an electrical current that repeatedly changes or reverses its direction opposite to that of Direct Current or DC, which always flows in a single direction as shown below From the graph, we can see that the charged particles in AC tend to start moving from zero. It increases to a maximum and then decreases back to zero completing one positive cycle. The particles then reverse their direction and reach the maximum in the opposite direction after which AC again returns to the original value completing a negative cycle. The same cycle is repeated again and again. Alternating currents are also accompanied usually by alternating voltages. Besides, alternating current is also easily transformed from a higher voltage level to a lower voltage level.
Read more

SOLAR TRANSFORMERS

-
Image
  The transformers required for wind power and solar DPV require special design features to meet the challenging operating conditions. The industry today has developed different types of transformers for the application. The last few decades have seen very rapid development of renewable energy, especially, distributed photovoltaic (DPV) and wind power. It is estimated that at least 40 per cent of electricity generation by year 2040 would be from renewable energy sources and this would give appreciable reduction of the present level of carbon dioxide emissions of about 10 billion tons per year. The transformer industry is rising to this challenge and has developed special transformers for the DPV generation and wind generation. Transformers are critical components in solar energy production and distribution. Historically, transformers have ‘stepped-up’ or ‘stepped-down’ energy from non-renewable sources. There are different types of solar transformers including distribution, station, su
Read more