FM is frequency modulation

-

 FM is short for frequency modulation, which refers to the means of encoding the audio signal on the carrier frequency. FM full power, low power, translator and booster stations operate in the 88 – 108 MHz band. There are many classes of radio stations. The smallest provide service to areas within three or four miles of a transmitter site; the largest provide service to locations more than 60 miles from a transmitter site. Only noncommercial educational radio stations are licensed in the 88-92 MHz “reserved” band. Both commercial and noncommercial educational stations may operate in the “non-reserved” 92-108 MHz band.

Comments

Post a Comment

Popular posts from this blog

UNMANNED POWER SUBSTATION SYSTEM

-
Image
  Unmanned Power Sub Station System An Unmanned Power Substation System refers to a modern and technologically advanced electrical substation that operates without the need for constant on-site human presence. These unmanned substations utilize automation, remote monitoring, and control technologies to efficiently manage potential events. Automation and Remote Control The system is equipped with intelligent devices and sensors that automate various tasks such as monitoring voltage, current, temperature, and other parameters. Remote control capabilities allow operators to manage the substation from our command center. Reduced Operation and Maintenance Costs With the elimination of on-site personnel, the operational and maintenance costs associated with manned substations are significantly reduced. Routine maintenance tasks can be scheduled and monitored remotely. Enhanced Reliability and Safety The use of automated systems ensures greater reliability and minimizes the risk of human ...
Read more

Difference Between AC And DC Motor

-
  Difference Between AC And DC Motor The difference between AC and DC Motor are discussed below: AC Motor vs DC Motor AC Motor DC Motor AC motor runs on alternating current. DC motors operate on direct current. There is no need for conversion of current in AC motors. Like AC. There is no need for conversion of current in AC motors. Like AC. AC motors are used where power performance is demanded for extended periods of time. DC motors are used where the speed of the motor needs to be controlled externally. AC motors can be single-phase or three-phase. All DC motors are single phase. In an AC motor the armature does not rotate while the magnetic field keeps rotating continuously. In a DC motor, the armature rotates while the magnetic field rotates. Repairing AC motors is not expensive. DC motors are very expensive to repair. Brushes are not used in AC motor. Brushes are used in DC motor. AC motors have a very long life span DC motors do not have a very long life span. The speed of AC...
Read more

MOSFET

-
  What is MOSFET? The MOSFET, also known as a metal-oxide-semiconductor field-effect transistor, is a type of FET with an insulated gate that is assembled by the controlled oxidation of that  semiconductor . The semiconductor used in it is generally silicon. In more detail, we can explain that it is a four-a terminal-based device that is composed of a, Source(S) Gate (G) Drain (D) Body (B) In a general overview, the body of a MOSFET is in connection with its source terminal hence forming a three-terminal device such as a field-effect transistor. It is normally considered a transistor and is utilized in both digital circuits and analog circuits. A MOSFET can function in two ways Depletion Mode Enhancement Mode Enhanced Mode Enhanced mode can be defined as if there is no voltage across the gate terminal then the device will not conduct. But when there is a maximum voltage present across the gate terminal then the conductivity of the device gets enhanced. Depletion Mode Depletion...
Read more